11/6/2022 0 Comments Estlcam reviewA list of mounts I have designed are below. Files can be found atĪ tool mount is also needed for your specific tool. Investing time on this up front is much better than printing parts for four days and then finding that your calibration or frame is off. If you have to square the frame, then you might also consider printing the Advanced frame test. If the test indicates that your frame is not square, then carefully check the frame and adjust, and retest. If your 3D printer is of questionable quality it is best to run a quick basic frame test to make sure the parts will print as intended. No support should be needed for any part I have designed. There are some steep walls so no more than 75% layer height to nozzle diameter. Two or more perimeters for through hole strength. Recommended Print Settings: PLA for dimensional accuracy (PETG is also acceptable, if your dimensions are verified good and you are willing to sacrifice some rigidity). Stainless steel tubing is more rigid and smooth, but also much more expensive, Dom is less expensive than Stainless but requires some coating to prevent rust. 065” (max is 0.120”) wall thickness stainless steel tubing or DOM. Hardware store steel EMT conduit works well and is inexpensive an upgrade would be. Some things are sold as Inside Dimension (ID) (conduit), or Outside Dimension (OD) (tubing). Anywhere else you must physically measure first. Please measure your rails before printing! 23.5mm fits ¾″ EMT conduit in the US. The measurement is for the Outside Diameter of the conduit/rails/tubing. There are 3 different sets of printed parts C-23.5mm, F-25mm, or J-25.4mm (1 inch). MPCNC Primo Parts ¶ Printed Parts Sizes ¶
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |